- How to remove a garbage disposal from kitchen sink how to#
- How to remove a garbage disposal from kitchen sink install#
The replacement faucet was a Kleo Spot Resist Stainless One-Handle High Arc Pulldown Kitchen Faucet, which is manufactured by Moen and found at most home centers. Richard replaced the kitchen sink with a T1823 Topmount Stainless Steel 3/4” Radius Sink, which is manufactured by MR Direct. Repeat the process backward from before.Step 6: Reconnect plumbing and drain connections
How to remove a garbage disposal from kitchen sink install#
Install clips to hold the sink in place. Gently place the sink into position and ensure it sits tightly against the countertop. Flip the sink upside down and apply silicon around the edges of the sink. Clean the countertop using a general household cleaning product. Tighten the nut by either using a special installation tool provided with the faucet or use a basin wrench or multi-purpose wrench plumbing tool. Place the mounting bracket and nut over the outlet hose. Place the plate and plate deck gasket on top of the sink. Usually, you would use plumber’s putty, but check the instructions to see if your plate needs it. To cover the two outside holes, use an escutcheon plate. Note: If you would like the faucet and handles as individual units, opt for a widespread faucet. Richard chose a single handle center set faucet, meaning the handle is directly connected to the spout. Read the instructions to see what your sink requires. For the sink that Richard used, he was able to install the basket strainer without plumber’s putty. Do as much work as you can on the countertop for easier access. If not, you’ll have to make adjustments to the countertop. Dry fit the new sink to ensure the opening of the hole is the same as the new sink. Using a putty knife, slide underneath the lip of the sink and carefully loosen it until it’s ready to pry free. Remove the clips holding the sink in place. 
Step 2: Disconnect the sink from the countertop The tailpiece should be released with a nut that can often be loosened from the P-trap first and then unthreaded from the drain.
Disconnect the drain tailpiece from either the P-trap of the garbage disposal, depending on your sink. 
Unthread the nuts holding the faucet in place and pull the faucet and hot and cold lines away from the sink.Disconnect supply lines using a wrench.Open the faucet to ensure all the water is drained from the lines and the shutoff holds. Turn off both hot and cold water supply valves.Steps for Replacing a Kitchen Sink: Step 1: Disconnect the plumbing and drain connections
How to remove a garbage disposal from kitchen sink how to#
How to Install the Plumbing for a Kitchen SinkĪs long as you find a sink with the same dimensions as your original basin, with the right tools, you can complete this project on your own.
0 kommentar(er)
